Safety Pack; Using Your Appliance; Use Of The Control Panel; Starting Your Appliance - Brandt TI1FSOFT Manuel D'instruction

d) Safety pack
Over-temperature protection. If the temperature inside the induction cooker
-
body is too high, the appliance will stop heating.
Over current or voltage abnormality protection. When voltage is abnormal or
-
current changes abruptly, the induction cooker will stop. Once the issues are solved,
the induction cooker will work again normally.
Container detection system. If a pot is moved during process, the unit will stop
-
heating immediately. The appliance will emit a sound and after 1 minute it will
automatically return to standby mode.
Automatic shutdown protection. When the time selected is reached, the
-
induction cooker will shut off automatically until the user triggers the timer again.
Control Lock (1). This pad allows locking all the control panel to simplify the
-
cleaning but also to preserve and safe children from all risks.

3) USING YOUR APPLIANCE

a) Use of the control panel
The sensitive pads work with a sense of touch. It is not necessary to put pressure on.
-
Use the base of your finger and not the tip as indicated on the images below
-
Slide your finger on the slider to increase or decrease the power.
-
You will hear a beep each time an action will be registered.
-
The control panel must be clean, dry and not be covered by an object or a cloth;
-
even a thin layer of water can create dysfunction.
b) Starting your appliance
After the power supplier is connected, the buzzer sounds and the screen show "L"(cold) or
"H"(hot), indicating that the the temperature of the cooking zone is less or higher than 60
degrees. Press on On/standby (6), screen show "----" indicating that the hotplate is in a state
of standby and ready to be programmed. You can now use the induction cooker.
Never put an empty container on the ceramic plate before switching on the
appliance.
Note:
Under the standby mode, if no function button is pressed for about 30 seconds, the
induction cooker will switch off automatically.
Under the working mode, if there is no proper pot on the ceramic plate, the LED display will
show "E1" and the induction cooker will beep and switch off automatically after 30 seconds.
24