End Sub-Menu - OHAUS SL Serie Guide De L'utilisateur

EN-24
3.5.4 Unit Sub-menu (Cont.)
Edit the Factor
When the Factor is displayed, the first digit is flashing. Press Yes to accept, or
No to display the next incremental value for this digit. When the desired value
flashes, press Yes to accept this value; this will activate the next digit. Press No
to change, or Yes to accept this value. Repeat for the other digits until all digits
have been accepted.
Note: To accept the Factor as a whole, each digit must be accepted, even if
this digit has not been changed.
When all digits have been accepted, the new Factor flashes on the display.
Press Yes to accept this Factor and display Exponent. Press No to re-edit the Factor.
Set the Exponent
When E appears on the display, press Yes to
edit the Exponent. Press No to go to the next
variable, LSD.
Change the Exponent
The first Exponent setting is flashed on the display. The Exponent settings are SET 0,
SET 1, SET 2, SET 3, SET -3, SET -2, and SET -1. Press No as each Exponent setting
is displayed to display the next setting. When the desired Exponent is displayed,
press Yes to accept this Exponent and go to the next variable, LSD.
Set the LSD
When LSD is displayed, press Yes to go to LSD
settings, or No to exit.
LSD settings are SET 1, SET 2, SET 5, SET 10,
SET 100 or SET 0.5. When a setting displays.
press No to go to the next setting. Press Yes to
accept a setting and exit.
End Unit
When END UNIT is displayed, press Yes to exit
the Unit Sub-menu and go to the End Sub-menu,
or press No to return to the first Menu Item in the
Unit Sub-menu.

3.5.5 End Sub-menu

When END is displayed, press Yes to exit the
MENU and begin weighing, or press No to move
to the Calibration Sub-menu.
Adventurer SL