Toro Turf Pro 6 Mode D'emploi page 19

What the Display Means continued...
Information Displayed When Operating
With the Function Switch set to RUN, each Dial setting shows:
No Program Running
– Automatic Mode
The current time with a flashing colon (:) is
displayed. If the entire display is flashing,
the controller has just been plugged in or there has
been a power outage and no battery power was
available during the outage. To stop the flashing,
+ -
press the or Buttons. If the colon is steady and
not flashing, the controller is using battery power.
Program Running
– Automatic Mode or
Manual Program Start shows the current time and
all active valves running. Turn the Dial to an active
valve to display which Program is activated and the
remaining run time. If you turn the Dial to a valve
that is not running, it will show "OFF" even though
time may be scheduled on a program.
Manual Valve Running
With the Dial pointing to the appropriate valve, the
display shows "M" for MANUAL, the valve number,
and the time remaining for the valve to run.
Rain Sensor
– If automatic operation is
suspended by the rain sensor, "SEN" will flash on
the display in all dial positions. The "SEN" display
can be disabled for two minutes by pressing the
+ -
or Button, however this will not allow automatic
watering operation. Manual operation is not
inhibited by the rain sensor. When the sensor is no
longer activated and automatic operation has
resumed, "SEN" will no longer be displayed.
Water Budget Adjustments
– The run time
you set is multiplied by the Water Budget value.
If this exceeds 9.9 hours, the display shows one,
two, or three bars before the program letter to
advise that more time, up to 11.8 hours,
is scheduled but cannot be displayed.
19