Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
6
Adjust the Temperature
This valve is NOT factory preset. Upon installation, the temperature of this
valve must be checked and adjusted to ensure delivery of a safe water
temperature. Water in excess of 110°F (43°C) may cause scalding.
Using the cover, turn the cartridge
B
gently until desired water temperature
is reached. Do not turn past stops as
this may damage the unit. Push the
cover down and tighten the screw.
7
End Outlet and Continuous Waste
FL-3L is shown
FL-3H is opposite
8" ref.
(203mm)
Waste Arm
Bradley Corporation • 215-1513 Rev. H; ECM 11-08-011
Loosen the cap screw
A
about ¼" (4–6 turns)
and lift up the cover (do
not remove).
Offset Lav Strainer
4" ref.
(102mm)
10¾" ref.
(273mm)
Tee End Outlet
Front View
H
C
P-trap
Waste Arm
2/15/2012
FL-3H, FL-3L
11
Publicité
Table des Matières
