Adjusting The Cutting Height - Worx WG788 Mode D'emploi

counter-clockwise. DO NOT OVER TIGHTEN
2. aSSEmBliNg ThE graSSBag (See
d1, d2 & d3)
1) Before starting to assemble the grass bag
(a) to the frame (b), check that the grass bag is
positioned to slip over the frame.
2) Slide the grass bag onto the frame.
3) Assemble the top clips to the frame, then
assemble the two side clips and the bottom
clip last.
3. FiTTiNg/rEmoViNg BaTTEry
(See E1, E2)
rEmoViNg BaTTEry
Disconnect the connector (c), then rotate the
battery locking knob (d) counter-clockwise.
Remove the battery by lifting it out of the
mower by the battery handle. (See E2)
NoTE: Be careful not to drop the battery onto
your foot or on the ground when removing it.
FiTTiNg BaTTEry
Put the battery into the battery container,
press the battery connector (c) and then rotate
the battery locking knob (d). (See E1)
14 14
4. haNdlE adjUSTmENT (See F)
The upper handle can be adjusted to 3
different height positions. Release the locking
cam lever, set the upper handle to one of the
three height positions, and make sure to insert
the pin into the hole. Then reset the locking
cam lever.
Note: Always check that the upper handle is
fixed firmly.
5. iNSTalliNg ThE graSS Bag (See
g1, g2 & g3)
FiTTiNg
1. Turn the mower off, wait until blade stops
and remove safety key.
2. Raise the safety flap and hold it up, ensure
that the mulching insert has been removed.
3. Pick up the grass bag by the handle, and
position grass bag on the lower hooks (e) on
the mower deck.
4. Release the safety guard to lock the grass
bag into position. Ensure the grass bag is
installed securely.
NoTE: Depress the grass bag slightly to
36V 19" Cordless lawn mower
ensure that it is completely installed.
rEmoViNg/EmPTyiNg
Lift the safety guard and hold it up. The grass
bag will drop automatically.

6. adjUSTiNg ThE CUTTiNg hEighT

(See h)
warNiNg! Stop, release switch lever
and wait until the motor stops before
adjusting height. The blades continue to rotate
after the machine is switched off, a rotating
blade can cause injury.
CaUTioN: do not touch rotating blade.
For the first cutting of the season, a high
cutting adjustment should be selected.
The lawnmower can be set to 6 cutting heights
between 1.5" (38mm) and 3.5" (88mm).
For this purpose, move the cutting height
adjustment lever outwards then adjust to the
preferred position.
OPERATION
1. STarTiNg aNd SToPPiNg (See i1, i2)
warNiNg! The blade continues
to rotate for a few seconds after the
machine is switched off. Allow the motor/blade
to stop rotating before switching "on" again.
Do not rapidly switch off and on.
STarTiNg:
warNiNg! The battery is disconnected
from your lawn mower and you must
insert the connector into the battery socket
before use.
1. Insert safety key (3) into the housing of the
switch box.
2. Push down the key, until safety key is fully
seated inside housing.
3. Press and hold the safety key, squeeze the
switch lever bar (2) towards the handle and
EN