Wall Or Ceiling Fastening - Videotec MAXIMUS MLX Manuel D'instructions

6.1.2 Wall or ceiling fastening

The product can be installed on a railing or ceiling.
Fasten the fastening support (01) to its final
installation surface.
Attach the housing support (03) to the fastening
support (01) using the M8 screw (05), washers and
nut. Once the final position of the product is defined,
fully tighten the M8 screw (05) and fasten the M5
screws (08) to block rotation.
The cable connected to the housing could hinder
operations The illuminator can be rotated 180°.
Fig. 11 Wall fastening with cable input upwards.
16
08
01
08
05
03
Fig. 12 Wall fastening with cable input downwards.
Fig. 13 Rear view of completed installation.
Pay attention to the fixing. Tightening
torque: M5 screws, 9Nm (±0.5Nm). M8
screw, 16.5Nm (±0.5Nm).
08
01
08
05
03
MNVCMLX_2222_EN