Assembly; Installation; Installation Of Wall-Mounted Illuminator - Videotec GEKO IRH Manuel D'instructions

6 Assembly

Fasten the top bracket (01) to the illuminator using
the screws and washers (02) supplied.
01
02
Fig. 3

7 Installation

7.1 Installation of wall-mounted
illuminator
The illuminator's position can be decided at
the time of installation.
Fig. 4
Fasten the bracket as shown in the figure. Drive the
wall screws in tight.
Fig. 5
6
Fasten the illuminator, complete with its bracket,
using the screw, the nut and the washer supplied.
02
Fig. 6
Set the illuminator's vertical and horizontal
inclination by adjusting the two fastening screws.
Fig. 7
Check the resulting illumination range on the screen.
Tighten all the screws.
MNVCIRHS_2222_EN