Safety Instructions; Important - BGS technic 62635 Mode D'emploi

Please read these instructions carefully. Note the safe operational requirements, warnings and
cautions. Use the product correctly and with care for the purpose for which it is intended. Failure to do
so may cause damage and/or personal injury and will invalidate the warranty. Please keep
instructions safe for future use.

SAFETY INSTRUCTIONS

WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are
adhered to when using tools.
WARNING! Always use caution when working around fuel systems. The fuel in the fuel rail may be
pressurised even if the engine is not running.
IMPORTANT: These instructions are provided as a guide only.
• Always refer to the vehicle manufacturer's service instructions, or a proprietary manual, to
establish the current procedure and data, also any warnings or cautions particular to the vehicle.
• DO NOT use the set if any parts are missing or damaged.
• DO NOT use this tool for any purpose other than that for which it is designed.
• Switch off vehicle's ignition and disconnect the battery before commencing work under the bonnet.
• You must follow the vehicle's service manual cautions when working around the air bag system. If
the cautions are not followed the air bag may deploy unexpectedly even after the ignition is turned
'OFF', resulting in personal in jury.
• Never lay tools on the vehicle's battery. This may short the terminals together, causing harm to
yourself, the tools, or the battery.
• Operate in a well ventilated area. Do not inhale fuel vapours.
• Wear approved eye protection.
• Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long hair.
• Keep children and other unauthorised persons away from the working area.
• Keep yourself, tools, and test equipment away from hot engine parts.
• Always keep a fire extinguisher close by, that is suitable for fuel electrical or chemical fires.
• NEVER smoke or have open flames near vehicle.
• Always relieve fuel pressure before disconnecting fuel lines from injectors.
• Use a rag to coyer fuel line fittings, when connecting or disconnecting fuel lines. Avoid contact with
fuel.
• Clean up ail fuel spills immediately and dispose of ail rags properly.
• Maintain the tool components in good and clean condition for best and safest performance.
• When work on the vehicle is finished, ensure all connections on vehicle are restored, and that
there are no tools left in the engine bay.
• Replace tools in the carrying case and store in a safe, dry, childproof location.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
CDI Injector Extractor Set
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Art. 62635
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed