Intended Use; Safety Informations - BGS technic 70107 Mode D'emploi

ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.

INTENDED USE

This tool set allows a removing of bearings and sleeves out of blind holes. By using the spreading
claws, witch are listed in table, the set is suitable for many bearings and sleeves. This set is suitable
for cars, motorcycles, agricultural machinery and other machinery.
TOOLS
1 Slide hammer, weight: 1430g, length: 370 mm
2-4d Spreading claw for bearing inner diameter 10-14 mm
2-4c Spreading claw for bearing inner diameter 15-19 mm
2-4b Spreading claw for bearing inner diameter 18-25 mm
2-4a Spreading claw for bearing inner diameter 25-32 mm

SAFETY INFORMATIONS

•
Keep children and unauthorised persons away from the work area.
•
Do not let any children play with the tool or its packaging.
•
Make sure that the work area is sufficiently illuminated.
•
Keep the work area clean, organised, dry and free from other materials.
•
Do allow untrained persons work with this tool set.
•
Do not make any changes to the tool.
•
Check all components of the tool and replace any damaged parts, do not use the tool if any
parts are damaged.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Blind Hole Bearing Puller Set
with Slide Hammer, 5 pcs.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 70107
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed