Control Menu - Chopin SDmatic Mode D'emploi

GB
82
SDmatic

6.3 Control menu

■ This menu allows testing of some functionality.
❏ To run the vibrator, press on the corresponding icon. Press it
again to stop the vibrator.
❏ To run the stirrer, press on the corresponding icon. Press it again
to stop the stirrer.
Take care of the rotor of the stirrer.
❏ To verify the status of the SDmatic closing contact, close and
open the SDmatic and check the corresponding icon.
Stirrer
Small arrow
■ To verify the measurement chain at the probe level, check the
value displayed on the second line of the text box.
❏ The value corresponds to the probe measurement. It should be
very close to zero. If this value is higher than 0.5 A, the
measurement probe is probably dirty and it must be cleaned. If the
value remains higher than 0.5 A after cleaning of the probe,
contact your Chopin representative.
Numerical value
Vibrator Position of the measurement
device (high/low)
Closing/opening contact
Probe
Measurement probe
value  0.5 A
User's manual
12/2016