Filling The Fuel Tank; Adjusting The Cutting Height; Checking The Engine Oil Level - Toro Recycler Manuel De L'utilisateur

Tondeuse 48 cm
Masquer les pouces Voir aussi pour Recycler:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36
Operation

Filling the Fuel Tank

Gasoline is extremely flammable and explosive.
A fire or explosion from gasoline can burn you
and others.
• To prevent a static charge from igniting the
gasoline, place the container and/or mower
directly on the ground before filling, not in a
vehicle or on an object.
• Fill the tank outdoors when the engine is
cold. Wipe up spills.
• Do not handle gasoline when smoking or
around an open flame or sparks.
• Store gasoline in an approved fuel container,
out of the reach of children.
Fill the fuel tank with fresh unleaded regular gasoline
from a major name-brand service station (Figure 10).
Important: To reduce starting problems, add
fuel stabilizer to the fuel all season, mixing it with
gasoline less than 30 days old.
Figure 10

Checking the Engine Oil Level

Service Interval: Before each use or daily—Check the
engine oil level.
1. Remove the dipstick, wipe it clean, and fully install
the dipstick (Figure 6).
2. Remove the dipstick and check the oil level
(Figure 6). If the oil level is below the Add mark on
the dipstick, slowly pour oil into the oil fill tube to
raise the oil level to the Full mark on the dipstick.
Do not overfill. (Max. fill: 0.59 l, type: SAE 30W
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
3. Install the dipstick.

Adjusting the Cutting Height

Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing
when adjusting the cutting height.
If the engine has been running, the muffler will
be hot and can severely burn you. Keep away
from the hot muffler.
Adjust the cutting height as desired. Set all four wheels
to the same height.
Note: To raise the mower, move the 2 cutting height
levers forward; to lower the mower, move them both
rearward (Figure 11).
7
Figure 11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

20636270j0000120637270k0000120638270l00001

Table des Matières