Fill Fuel Tank With Gasoline - Toro Recycler 48 Mode D'emploi

2. Remove dipstick by rotating cap
counterclockwise 1/4 turn.
3. Wipe dipstick and insert it into filler neck.
Rotate cap 1/4 turn. Then remove dipstick and
check level of oil (Fig. 7). If level is low, add
only enough oil to raise level to FULL mark on
dipstick. DO NOT FILL ABOVE FULL
MARK BECAUSE ENGINE COULD BE
DAMAGED WHEN STARTED. POUR OIL
SLOWLY.
Note: Check oil level each time mower is
used or after every 5 hours of mower
operation. Initially, change oil after the
first 5 hours of operation; thereafter,
change oil after every 50 hours of
operation. More frequent oil changes
are required in dusty or dirty
conditions.
4. Insert dipstick into filler neck and rotate cap
clockwise 1/4 turn to lock it in place.
GB–8

Fill Fuel Tank With Gasoline

POTENTIAL HAZARD
In certain conditions gasoline is extremely
flammable and highly explosive.
WHAT CAN HAPPEN
A fire or explosion from gasoline can burn
you, others, and cause property damage.
HOW TO AVOID THE HAZARD
Use a funnel and fill the fuel tank outdoors,
in an open area, when the engine is cold.
Wipe up any gasoline that spills.
Do not fill the fuel tank completely full.
Add gasoline to the fuel tank until the level
is 6 mm to 13 mm (1/4" to 1/2") below the
bottom of the filler neck. This empty space
in the tank allows gasoline to expand.
Never smoke when handling gasoline, and
stay away from an open flame or where
gasoline fumes may be ignited by a spark.
Store gasoline in an approved container
and keep it out of the reach of children.
Never buy more than a 30-day supply of
gasoline.
Note: The Toro Company strongly
recommends the use of fresh, clean,
UNLEADED regular grade gasoline in
Toro gasoline powered products.
Unleaded gasoline burns cleaner,
extends engine life, and promotes good
starting by reducing the build–up of
combustion chamber deposits. Leaded
gasoline can be used if unleaded is not
available.
1. Clean around fuel tank cap and remove cap from
tank (Fig. 7). Do not fill tank full. Using
unleaded gasoline, fill fuel tank to within 6 to 13
mm (1/4" to 1/2") from top of tank, not into
filler neck.
2. Install fuel tank cap and wipe up any spilled
gasoline.