Troubleshooting Guide - GRAUPNER Arligh Burke Notice

Troubleshooting Guide

Problem possible error
Motor will not Motor cable unplugged / demo-
start lished
Drive battery empty
Remote control does not work
correctly, incorrectly adjusted
throttle trim
Defective motor
Throttle set incorrectly
Motor runs in Servo reverse switch throttle
reverse displaced
Engine has no Drive battery is almost empty
power
Throttle set incorrectly
Drive is running hard
Drive is very loud
Motor gets very hot
Model is dif- Transmitter battery empty
ficult to control
Displaced steering trim
Interference
Throttle set incorrectly
Model has no Transmitter and receiver are not
function bound
Interference
Displaced throttle trim
LEDs on the transmitter does
not light up
Model is very Propeller was damaged
noisy
Shaft is dirty or difficult to move
Screws are loose
Components have dissolved
Actions
Plug in cable / new solder
Changing the battery or charging
Check remote control, adjust trim correctly
Replace the motor
Set trim to neutral
Bring servo reverse switch into the correct position
Changing the battery or charging
Set trim to neutral
Check drive, clean and grease the shaft
Check shaft and motor
Allow engine to cool, check engine, install water
cooling, clean and grease the shaft
Change batteries or recharge batteries
Check and adjust steering trim
Take a short break and then re-try
Set trim to neutral
Transmitter and receiver rebind (manual of the trans-
mitter)
Take a short break and then re-try
Set trim to neutral
Check that the model and transmitter are turned on.
Check for empty batteries
Replace the propeller
Clean the shaft and regrease
Check the placement of all screws and tighten.
Check all components and attach them again
19