RIB BOSS 230V SLAVE Mode D'emploi page 34

G
INSTALLATION OF 2 MOTOR BOSS ON DOORS UP TO 12 m
B
LEVER APPLICATION
55 mm
35 mm
ASSEMBLY OF PAIR OF STRAIGHT LEVERS (code ACG8720) BETWEEN MOTOR AND UPPER DOOR
FRAME
N.B.: THE PAIR OF STRAIGHT TELESCOPIC LEVERS can be mounted when there is a 15 mm
minimum space guaranteed between the moving part of the door and the exterior door
frame containing the counterweight.
- Rivets or screws should be used to fix corner parts to the upper frame, in line with
measurements shown in Fig. 4: if at the measurement of 35 mm, one finds the reinforcing
plate of the door frame, it is possible to fix the brackets directly above this reinforcing
plate even if the measurement will not be maintained.
In the event that the up-and-over door is already pre-fitted for automated movement, use
the attachments provided. Do not use the angles provided.
- Insert the sliding arm sleeve into the angles and secure the pivots and split pins (Fig. 4).
- Make sure that the casing does not touch the up-and-over door movement levers when
mounted.
Note: The length of the sleeve and of the sliding arm must be modified in function of overhead door height. Trim the sleeve and the sliding arm so that the sleeve rests 40 mm from the center
of the drawbar pivot pin and the sliding arm avoids contact with the rotating dowels located on the angles (Fig. 5A)
LONG MOUNTING PLATE (FOR NON-AUTOMATED UP-AND-OVER DOORS)
Code ACG8188
Position the mounting plate with the upper section (slotted hole to feed electric cable) in top
position (Fig. 6).
Fix the mounting spar flush against the upper moving part of the up-and-over door distance of
17 cm from the internal cable of the sheath using 6.3 x 13 self-tapping screws (not included).
17 cm
After the assembly's completion, either with the LONG
MOUNTING PLATE or with the SHORT MOUNTING PLATE, the
reducer's outlet-shaft must be placed in a distance of
80±10 mm from the pivot-axle of the up-and-over door's
little arm.
ANGLE IRONS
40 mm
4
6
2
LEVERS SLEEVE
5A
ASSEMBLY OF PAIR OF CURVED LEVERS (code ACG8722) BETWEEN MOTOR AND UPPER DOOR
FRAME
N.B.: The PAIR OF CURVED TELESCOPIC LEVERS should be mounted when there is less than
the 15 mm minimum space guaranteed between the moving part of the door and the
exterior door frame containing the counterweight.
- In the event that the up-and-over door is already pre-fitted for automated movement, use
the attachments provided. Do not use the angles provided.
- Insert the sliding arm sleeve into the angles and secure the pivots and split pins (Fig. 4).
- Make sure that the casing does not touch the up-and-over door movement levers when
mounted.
SHORT MOUNTING PLATE (FOR AUTOMATED UP-AND-OVER DOORS)
Code ACG8189
Calculate the length, L = C - 410 [mm], to which the mounting plate should be vertically fixed
(Fig. 7-8).
Position it on the appropriate vertical supports while keeping the upper part (slotted hole to
feed electric cable) in a vertical position facing upwards.
Fix the mounting plate distance of 17 cm from the internal cable of the sheath using the four
feedthrough holes, four 4 metric screws (M6x25) and self-locking nuts (not supplied).
C
L = C - 410 mm
ANGLE IRONS
LEVERS SLEEVE
5B
L
7
L
8