Thermador HDDW 36DS Mode D'emploi page 4

IMPORTANT INFORMATION:
Old appliances are not worthless rubbish. Valuable raw
materials can be reclaimed by recycling old appliances.
Before disposing of your old appliance, render it unusable.
You received your new appliance in a protective
shipping carton. All packaging materials are environmen-
tally friendly and recyclable. Please contribute to a better
environment by disposing of packaging materials in an
environmentally-friendly manner.
The extractor hood can only be used in exhaust air
mode.
Always mount the extractor hood over the center of
the hob.
Minimum distance between electric hob and bottom
edge of extractor hood: 30" mm, Fig. 1.
The extractor hood must not be installed over a solid
fuel cooker – a potential fire hazard (e.g. flying sparks) –
unless the cooker features a closed, non-removable
cover and all national regulations are observed.
The smaller the gap between the extractor hood and
hotplates, the greater the likelihood that droplets will form
on the underside of the extractor hood.
Fig. 1
GAS
Additional information
concerning gas cookers:
When installing gas hotplates, comply with the relevant
national statutory regulations.
Always comply with the currently valid regulations and
installation instructions supplied by the gas appliance
manufacturer.
Only one side of the extractor hood may be installed
next to a high-sided unit or high wall. Gap at least 2".
Minimum distance on gas hotplates between the upper
edge of the grate and lower edge of the extractor hood:
30", Fig. 1.
Abb. 1
ELECTRIC
PAGE 2