De'Longhi BAR 4FS Mode D'emploi page 2

bar 4 int 26-09-2000
A) If your appliance comes fitted with a plug, it will incorporate a
13 Amp fuse. If it does not fit your socket, the plug should be cut
off from the mains lead, and an appropriate plug fitted, as
below.
WARNING: Very carefully dispose of the cut off plug after
removing the fuse: do not insert in a 13 Amp socket elsewhere
in the house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must
be protected by a 15 Amp fuse.
WARNING - THIS APPLIANCE MUST BE EARTHED
The wires in the mains lead are coloured in accordance with the fol-
lowing code:
Green and yellow:
Blue:
Brown:
13:55 Pagina 3
J
I
H
K
G
ELECTRICAL CONNECTION (UK ONLY)
IMPORTANT
Earth
E
Neutral
L
N
Live
A
@@@@@ PPPPP
@@@@@ PPPPP
If the plug is a moulded-on type, the fuse cover must be re-fitted
when changing the fuse using a 13 Amp Asta approved fuse to
BS 1362. In the event of losing the fuse cover, the plug must
NOT be used until a replacement fuse cover can be obtained
from your nearest electrical dealer. The colour of the correct
replacement fuse cover is that as marked on the base of the
plug.
B) If your appliance is not fitted with a plug, please follow the
instructions provided below:
As the colours of the wires in the mains lead may not correspond
with the coloured markings identifying the terminals in your plug,
proceed as follows:
The green and yellow wire must be connected to the terminal in the
plug marked with the letter E or the earth symbol
green or green and yellow.
The blue wire must be connected to the terminal marked with the let-
ter N or coloured black.
The brown wire must be connected to the terminal marked with the
letter L or coloured red.
B
C
D
E
F
or coloured