Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3
Mark the installation location
+
Place the station against the wall
+
Choose a location that can support the
weight of the station and cable
+
Mark the two lower mounting holes
4
Mark the mounting location
+
Line up the mounting holes and tape the installation template against the
wall
+
Mark the top mounting hole on the wall with the installation template
+
Remove the template
WARNING: Before beginning to drill, make sure the area has no
water pipes or electrical wiring. You may need to relocate the
station to avoid these.
5
For concrete walls
a
+
Drill three holes with concrete drill bit
+
Install anchors
5
For wood walls
b
+
Drill three holes with standard drill bit
6
Install top mounting screw
+
Use driver bit to drill a screw into the
top-most mounting hole, leaving a 3 mm
gap under the screw head to hang the
station on
+
Keep the remaining 2 screws for use later
chargepoint.com 5
Publicité
Table des Matières
