Time; Displaying The Time; Setting The Time (Timeset); Selecting 12/24-Hour Clock Mode - Bosch Dover USB40/80 Mode D'emploi Et De Montage

36 | en

Time

Displaying the time

In order to display the time for about 10 sec-
onds,
f Hold down the MENU 5 button for
longer than 2 seconds.
Note:
Depending on the selected clock
mode, either "24H" will be shown in
front of the time when in 24-hour
mode, or, in 12-hour mode, "AM" (in
the morning) or "PM" (in the
afternoon).
Read the section on "Selecting
12/24-hour clock mode" in this
chapter to see how to set the clock
mode.

Setting the time (TIMESET)

f Press the MENU 5 button to open the
menu.
f Press the MENU 5 button repeatedly
until "TIMESET" appears on the display
along with the current setting.
The current time will be shown on the display
after about 2 seconds. Either "24H" will be
shown in front of the time when in 24-hour
mode, or, in 12-hour mode, "AM" (in the
morning) or "PM" (in the afternoon). The hours
flash, and can be adjusted.
To adjust the hours or minutes,
f Turn the volume controller 1 to the left
or right.
7 620 000 120 - 123 | 10.2010
To switch between hours and minutes
f Press the 6 : button.
f Press the MENU 7 button, repeatedly if
necessary, to close the menu.

Selecting 12/24-hour clock mode

(MODE)
f Press the MENU 5 button to open the
menu.
f Press the MENU 5 button repeatedly
until "MODE" appears on the display along
with the current setting.
f Turn the volume controller 1 to the left
or right in order to change between the
settings.
f Press the MENU 5 button, repeatedly if
necessary, to close the menu.
Switching the alarm on/off and
adjusting the alarm time (ALARM)
You can set an alarm time at the device for a
one-off alarm. When the set time arrives, an
alarm signal will sound for about 15 seconds
and "ALARM" will flash on the display.
Note:
f In order to interrupt the alarm
early, press any button (other
than the On/Off button 3 or
the eject button 4 ). The device
then switches into normal
operating mode.
The alarm is also given if the
f
device is already switched on at
the time of the alarm.
Robert Bosch Car Multimedia GmbH
Time