SEVERIN KS 9952 Mode D'emploi page 13

Masquer les pouces Voir aussi pour KS 9952:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.
Temperature control and interior light
2.
Storage shelves
3.
Drain channel cleaning tool
4.
Storage shelf
5.
Vegetable/fruit fresh storage compartment
6.
Bottle storage
7.
Multi-purpose storage
8.
Egg storage
9.
Instructions for using freezer
10. Ice-cube tray
11. Storage shelf
12. Compressor
13. Melt-water evaporation tray
14. Condenser
Before using for the fi rst time
∙ Remove any exterior and interior packaging materials
completely, including the adhesive strips.
∙ The packaging materials must be properly disposed of.
∙ Fit the two enclosed spacer elements (1) into the
corresponding guide slots on the rear (2).
∙ Before it is connected to the mains, the unit must be
thoroughly checked for transport damage, including its
power cord.
∙ Clean the unit as described in the section De-frosting
and cleaning.
∙ The unit should only be transported in its vertical
position; do not tilt any more than 30°.
∙ Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
∙ If the unit has been tilted more than 30° during transport,
allow it to stand upright for at least 4 hours before it is
connected to the mains.
∙ When the unit is fi rst switched on, a slight 'new' smell
may be noticed. However, this will disappear once the
cooling process has begun.
Installation
∙ The appliance should be set up in a well-ventilated, dry
room.
∙ It should be operated in conditions where the relative
humidity is no more than 70 %.
∙ The product data sheet at the end of this manual
contains details of the ambient temperature range
suitable for this appliance.
∙ Do not use the appliance outdoors.
∙ Ensure that the plug is accessible and can be removed
from the wall socket at any time.
∙ Do not expose the appliance to direct sunlight, and do not
position it next to any heat sources (radiators, cookers
etc.). If this cannot be avoided, however, suitable insulation
must be in installed between the heat source and the unit.
∙ The unit must not be installed inside a cabinet, nor directly
below a hanging cupboard, shelf or similar object.
∙ In the case of uneven fl oors, the adjustable feet on the
unit can be used to compensate and ensure optimum
stability.
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ks 9953Ks 9954Ks 9955Ks 9956Ks 9957

Table des Matières