Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
"dEHUMIdIFy" FUnCTIOn In TF-SwITCHIng MOdE
The "dehumidify" function is set when the set on-load humidity value is greater
than the off-set humidity value. The control is carried out by the relay F1 or F2.
Behavior of relay F1 or F2
Abbreviations:
F1
measured relative humidity at the indoor sensor
F1 EIn
setpoint for the switch-on humidity
F1 AUS
setpoint for the switch-off humidity
Relay F1 turns on when F1 ≥ F1 On
Relay T1 is switched off when F1 ≤ F1 AUS
nOTE: All relays are switched off if the indoor sensor or outdoor sensor is
faulty or not connected.
dEHUMIdIFy
HUMIdITy
F1 ON
F1_EIN
F1_EIN
F1 OFF
F1_AUS
F1_AUS
Switch-on point
hysteresis
Hysterese
F1(2)
F1(2)
TIME
Switch-off point
Professional humidity switch PLS1000 | 79
Professional humidity switch PLS1000
| 81
Publicité
Table des Matières
