OHAUS Valor 1000W Serie Guide De L'utilisateur page 10

EN-8
4.3 Restore Settings to Default
Press and hold SET, then
default user settings [F1-0 x].
Press YES to confirm displayed setting and proceed to next menu item.
Press SET to save and exit.
4.4 Set Tare Capacity
Press and hold SET, then
tare capacity settings [tArE x], where x:
0 = 2/3 of scale capacity
1 = 100% of scale capacity
Press to toggle through available settings, then press SET to save and exit.
5. SCALE SETUP AND SPAN CALIBRATION
For best results, calibrate the scale at regular intervals. Temperature changes,
gravity variations and abuse are some reasons why a scale may need recalibration.
Enter calibration as follows:
• Turn the scale on.
• During the start-up display [000000...999999], press and hold SET until
[FS--SP] is displayed.
• Press YES to display [P
• Press
to toggle through settings: 0, 1, 2, 3, 4
• Press YES to select, then display [d
• Press
to toggle through settings: 1, 2, 5, 10, 20, 50
• Press YES to select, then display scale capacity [xxxxxx] (kg)
• Press YES to select, then display [noLoAd]
• Make sure pan is empty, then press YES to display [LoAd]
• Press YES to select, then display default or last used span weight [xxxxxx] (kg)
• Press
, ,
• Place indicated weight on the scale, then press YES
• [CALEnd] is momentarily displayed to indicate calibration was successful, then
exit to weighing mode
• To abort calibration at any point, turn the scale off.
Examples:
Parameters: 3 x 0.0005 kg
P
d
Capacity
until [SEt-F2] is displayed. Press YES to enter and view
until [SEt-F3] is displayed. Press YES to enter and view
x], where x = position of decimal point
to edit the displayed value (as needed)
6 x 0.001 kg
4 3
5 1
3.000 6.000
OHAUS Valor
x], where x = scale divisions
15 x 0.002 kg 30 x 0.005 kg
3
2
15.000
TM
1000W Series
30 x 0.01 kg
3
5 10
30.000 30.000
3