Cannon DIGI-TROLL 5 Manuel De L'utilisateur page 13

noTE: It is strongly recommended to power your downrigger with a Deep-Cycle marine battery. Only run a Digi-Troll
from a Starter battery if it is recharged by an alternator while trolling.
noTE: Control degradation of the power cables and limit corrosion by using anti-oxidant gel on all connections.
RIGGInG AnD InSTALLATIon GUIDELInES:
For safety and compliance reasons, we recommend that you follow American Boat and Yacht Council (ABYC) standards
when rigging your boat. Altering boat wiring should be completed by a qualifi ed technician. The following specifi cations
are for general guidelines only:
CAUTIon: These guidelines apply to general rigging to support your Cannon Downrigger. Powering multiple
Downriggers or additional electrical devices from the same power circuit may impact the recommended wire gauge. If
you are using wire longer than that provided with your unit, follow the chart below. If you are running more than 30 feet
from the battery, we recommend that you contact a qualifi ed marine technician.
WIRE SPECIFICATIonS:
0-15 ft. (0-5 meters)
15-25 ft. (5-8 meters)
25-30 ft. (8-9 meters)
PoWERInG MULTIPLE DoWnRIGGERS
When operating multiple downriggers, run a maximum of 2 downriggers per dedicated battery. The advanced features
of the downriggers can keep the unit working virtually all the time. (See below for the recommended wiring setup.)
TyPICAL oPERATInG TIME*:
1 Digi-Troll per battery – 24 hours.
2 Digi-Trolls per battery –10 hours.
*Time based on lab results using a 15lb weight and Deep-Cycle batteries. Actual run time will vary.
Red (+)
black (-)
©2016 Johnson Outdoors Marine Electronics, Inc.
FUSE/bREAKER SPECIFICATIonS:
10 gauge 30 Amp, 32 Volt, waterproof, fast blow
8 gauge
6 gauge
WIRInG THE DoWnRIGGER
cannondownriggers.com | 13