Function Buttons - Sunny Health & Fitness SF-RB4616 Mode D'emploi

FUNCTION BUTTONS

MODE: Press this button to select functions.
SET: Press to set values of time, distance, calories, or pulse when
not in SCAN mode.
RESET: Press to reset time, distance, and calories to zero when not in
SCAN mode.
Press and hold for a few seconds to reset all values.
Meter will power on when you press any button or when you start to pedal. Once you start
pedaling, the meter will start counting. After approximately 4 minutes of no activity, the meter will
automatically shut off. This meter can (1) count the value from this workout (2) countdown from a
value you set.
FUNCTIONS
SCAN: Press MODE until pointer points to SCAN. Display will rotate through all 6
functions: Time, Speed, Distance, Calorie, ODO, and Pulse. Pointer will point to
the function being displayed. Each function will display for 4 seconds. If you want
to view a specific function, press MODE until the pointer points to the function you
want.
TIME:
Displays time of your exercise session.
SPEED: Displays current speed.
DISTANCE: Displays distance you have pedaled.
CALORIES:
Displays the approximate number of calories burned.
ODOMETER: Monitor displays the total accumulated distance. Pressing RESET does not reset
the odometer. Taking out the batteries resets the odometer.
PULSE: Press MODE until the pointer points to PULSE. Before measuring your pulse rate,
place both palms of your hands on both contact pads and the monitor will show
your current heartbeat rate in beats per minute (BPM) on the LCD after 6~7
seconds.
During the process of pulse measurement, the measurement value may be higher
than the virtual pulse rate during the first 2~3 seconds, then will return to normal
level. The measurement value cannot be regarded as the basis of medical
treatment.
The meter has a countdown function for TIME, DISTANCE, and CALORIES. To use the
countdown function, press MODE to select TIME, DISTANCE, or CALORIES. Press SET to set
the value, and then you can start pedaling. The meter will countdown from the value you set.
When the countdown is done, it will automatically start counting from 0.
NOTE:
If the display is faint or nonexistent, replace the batteries. When you replace the
batteries replace both at the same time. Do not mix battery types. Do not mix old
and new batteries. Dispose of old batteries according to your state and regional
guidelines.
EXERCISE METER
15