EUROM Polar 70 Manuel D'instruction page 71

c. After the TIMER OFF is set, it takes half a second before the remote control
transmits the signal to the air conditioner. After approximately 2 seconds,
the 'h' signal disappears and the set temperature appears again on the LCD
display. The timer function control light on the airco goes on.
Important: setting the time in the Timer: 0.5, 1, 1.5, 2, 2.5, 3, 3.5, 4, 4.5, 5, 5.5,
6, 6.5, 7, 7.5, 8, 8.5, 9, 9.5, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 23
and 24.
Examples:
The airco must start operating in 6 hours.
TIMER ON
1. Press the TIMER ON button, the signal 'h' appears on
the display.
2. Press on the TIMER ON button to show '6.0h' on the
display.
3. Wait approximately 3 seconds and the digital display will
show the temperature again. The function is now
activated.
The airco must stop operating in 10 hours.
TIMER OFF
1. Press the TIMER OFF button, the signal 'h' appears on
the display.
2. Press on the TIMER OFF button to show '10h' on the
display.
3. Wait approximately 3 seconds and the digital display will
show the temperature again. The function is now
activated.
Stopping the airco 2 hours after setting and restarting it 10
hours after setting
TIMER OFF-TIMER ON (ON-OFF-start)
1. Press the TIMER OFF button.
2. Press on the TIMER OFF button again to show '2.0h' on
the display.
3. Press the TIMER ON button.
4. Press on the TIMER ON button again to show '10h' on
the display.
5. Wait approximately 3 seconds and the digital display will
show the temperature again. The function is now
activated.
71