Funkwerk elmeg IP60 Mode D'emploi page 6

Setting up and connecting
Check that the pack contains everything it should.
Using the telephone receiver cable, connect the telephone receiver to the telephone
base. To do this, insert the short end of the coiled receiver cable into the socket on
the receiver. Insert the long end into the socket on the bottom of the telephone base.
To be able to make calls using the Internet, you need to establish a connection from
your telephone to the Internet. Using the LAN cable, connect the LAN connector on
your telephone to the LAN connector on a router or a telephone system with a router
function, for example an elmeg hybrid 300/600.
Connect your telephone to a mains socket using the power pack supplied.
Note: For your telephone to work, the power pack must always be plugged in. The
telephone will only work when connected to the mains.
Place the telephone on a non-slip surface.
Default settings
The IP60 device is delivered ex works with these default settings:
Operation Mode
Users
Password
IP address
Netmask
Bridge
Admin
funkwerk
DHCP Client
255.255.255.0