Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.2 Fan Installation
1.
Install the fan housing according to the minimum dimensions for
your appliance listed in Section 1.4 on page 5. See (i) below.
2.
Attach the duct boot or wall stack to fan housing using the (4)
provided self-tapping screws . The screws must be fastened on
the sides of the duct boot or wall stack for proper finishing. See
(i) below.
3.
Secure the fan housing and duct boot/wall stack to the wall
Figure 2.5, Fan Assembly Installation
10
i
iii
v
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
studs with (4) provided black wood screws. See (ii) below.
4.
Finish the wall around the fan housing.
5.
Attach the fan cover plate to the fan housing using (4) screws.
See (iii) and (iv) below.
6.
Fit the air grille to the frame through the brackets with (2) screws
provided. See (v) and (vi) below.
7.
Complete wiring. Refer to Section 3.0 on page 12.
ii
iv
vi
Heat Transfer Kit #HTK-INT R.7
Publicité
Chapitres
Table des Matières
