Programme End; Option Buttons - Hoover HDIN 4S613PS/E Manuel D'utilisation

Programme interruption
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes) the machine stops automatically.
Close the door, without pressing any buttons.
The cycle will start from where it left off.
WARNING:
If you open the door during the drying
cycle, an intermittent audio signal
advises you that the drying cycle has
not yet finished.
Changing a running programme.
Proceed as follows to change or cancel a
running program:
l
Open the door.
l
Keep the START/RESET button pressed
for at least 3 seconds. "RESET" will
appear on the display and acoustic
signals will be emitted.
l
Close the door of the appliance.
l
The running programme will be cancelled.
l
At this point a new programme can be set
using the "PROGRAMME SELECTION"
button.
WARNING:
Before starting a new programme, you should
check that there is still detergent in the
dispenser. If necessary, top up the detergent.

Programme end

A 5 second buzzer will sound (if not muted)
3 times at 30 second intervals to signal that
the programme has ended.
Only for models with the "OPEN DOOR"
option, during the drying phase the
door will open automatically and you
will have to wait until for the end-of-
cycle signal before removing the dishes.
POWER WASH
(only on some models)
In some programmes (see table of programmes),
the third washing arm, positioned at the
bottom of the dishwasher POWER WASH,
will also be enabled. This feature is ideal
when cleaning heavily soiled tableware or
cookware, placing them directly in the area
of the basket above the POWER WASH arm.

Option buttons

The option buttons provide you with further
wash options, allowing you to customise the
wash programmes (see the table in chapter
17 for a list of programmes on which each
option can be enabled). Options are
enabled (or disabled) before starting the
programme, using the appropriate buttons.
The relevant indicator lights will appear (or
disappear) on the display. The option button
should be enabled after you have chosen
the wash programme.
If an option is selected that is not
compatible with the selected programme
then the option indicator light first flashes
and then goes off.
107
POWER WASH