Hoover HDIN 4S613PS/E Manuel D'utilisation page 110

l
Hold down the "PROGRAMME SELECTION"
and "ON/OFF" buttons for about 5 secs.
l
The message "SETTINGS" will appear
on the display and the indicator lights of
the "OPTIONS" and "EXTRA DRY"
buttons will be on.
l
Pressing the "PROGRAMME SELECTION"
button until the "MEMO FUNCTION"
parameter is selected.
l
Parameter adjustment is performed by
pressing the "OPTIONS" and "EXTRA
DRY" buttons to change the value from
"MEMO MODE ON" to "MEMO MODE
OFF" and vice versa.
l
Switch off the dishwasher by pressing the
"ON/OFF" button for 3 secs to confirm
the new setting.
To turn the alarm on again, follow the same
procedure.
Enabling or disabling DEMO MODE
(be used exclusively in stores)
Enabling
The dishwasher must ALWAYS be off
before you start this procedure.
1. Open the door.
2. Turn on the
ON/OFF button.
3. Press the "PROGRAMME SELECTION".
and "DELAY START" buttons together
for 5 seconds.
4. "DEMO MODE ON" will appear on the
display.
5. If no button is pressed for 30 seconds,
the programme will start, simulating the
start of a wash programme.
appliance using
The PROGRAMME SELECTION/OPTIONS/
DELAY START options are enabled,
and by pressing these buttons you can
simulate the
without starting a wash.
Disabling "Demo mode"
WARNING
Once installed, if the appliance works
correctly but the wash cycle does not
start upon pressing the Start button,
"Demo mode" may not have been
disabled.
The dishwasher must ALWAYS be off
before you start this procedure.
1. Open the door.
2. Turn on
ON/OFF button.
3. Press the "PROGRAMME SELECTION".
and "DELAY START" buttons together
for 5 seconds.
4. "DEMO MODE OFF" will appear on the
display.
5. Switch off the appliance.
the
110
product's functioning
the appliance using the