Parallel Connection - Niko 101-78050 Mode D'emploi

1XX-7805X
To block the shift to the manual mode, connect the voltage (the
same phase as the power supply voltage) to the external input
terminal 1 (E1) of the actuator.

4.4. Parallel connection

In installations with several motion detectors that are connected
in parallel, the lamps may not be illuminated in the detection area
of different motion detectors, because, for example, when the
first sensor switches off the lighting, the second sensor registers
the lowering temperature and switches the lighting on again. The
minimum load required remains 40 W.
4.5. In combination with Nikobus
Tip: Ensure that there is sufficient ambient light while
programming.
Starting mode: The Nikobus module is not in programming
mode. All bus participants that automatically send Nikobus
telegrams (such as timers, light sensors and other sensors from
117 EN