Niko 101-78050 Mode D'emploi page 109

1XX-7805X 1XX-7805X
The motion detector (sensor) is intended for indoor use only in
an environment with non-condensing atmospheric humidity.
This sensor is combined with a Nikobus base (actuator) with two
entries to which an external push button (phase L, 12 Vac) can
be connected. With this push button, you can control the motion
detector from various locations.
The device (actuator + sensor) is supplied on a pre-assembled
metal base (45 x 45) and is available with an actuator without
claws (1XX-78050) or an actuator with claws (1XX-78051). The
flush surround plate must be ordered separately.
2. INSTALLATION
2.1. Connection
Danger: Disconnect all power before installing the flush-mounting
motion detector. Do not connect the device to the mains voltage
until installation has been completed (including the flush surround
plate).
EN 108