GYS BT282 Mode D'emploi page 4

Pour tester des batteries 12 volts: sae : 40~1200 cca din : 20~670 cca iec : 25~790 cca en : 35~1125 cca ca(mca) : 70~1440 ca(mca)
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7. Press "ENTER" to the next step.
8. Please press \ key to input the battery capacity of CCA or
CA(MCA)
SAE : 40~1200 CCA DIN : 20~670 CCA IEC : 25~790 CCA
EN : 35~1125 CCA CA(MCA) : 70~1440 CA(MCA)
Press "ENTER" to begin the test.
9. Test the battery within 1 second.
10. If the display shows BAT. & XX.XXv, please recharge the battery
then re-test. If reading is the same, the battery should be replaced
immediately.
11. If the display shows BAT.CHARGED (Is tested battery charged?),
please press \
"ENTER" to the next step. (BT282 tester will judge the
tested battery status & decide to show out Step11.)
12. When the test is complete, the LCD shows the actual voltage and
actual CCA. Press the \ key to see the SOC (STATE OF
CHARGE) , SOH (STATE OF HEALTH) or m� (Internal
Resistance). HI or LO m� means it is out of range.
One of following five results will be displayed:
OK
OK
RECHARGE
key to answer YES or NO then press
The battery is good & capable of holding a charge.
The battery is good but needs to be charged.
- GB.4-V1 -

Publicité

Table des Matières
loading

Table des Matières