GYS BT282 Mode D'emploi page 3

BATTERY TEST- 12V
1. Before you test a battery in a vehicle, turn off the ignition, all
accessories and loads. Close all the vehicle doors and the trunk lid.
NOTE: If vehicle has been running before testing, the battery
holds a surface charge. Turn on headlights for 30 seconds to
remove surface charge. Let battery rest for one minute
before starting to test.
2. Make sure the battery terminals are clean. Wires brush them if
necessary. Clamp the black load lead to the vehicle negative battery
terminal. Clamp the red load lead to the vehicle positive battery
terminal.
3. LCD lights on and shows the voltage of the battery XX.XXv on the
screen. Please press \ key to select BAT. for battery tester.
Press "ENTER" to the next step.
NOTE : If you see HI / LO / blank / RIPPLE appeared on the
screen or flickers, please refer to TROUBLESHOOITING.
4. Please press \ key to select the battery type of
SLI / AGM / VRLA/GEL:
SLI : Standard SLI flooded batteries.
AGM : AGM sealed batteries.
VRLA/GEL : VRLA/GEL sealed batteries.
5. Press "ENTER" to the next step.
6. Please press \ key to select the battery rating of
SAE/CCA , DIN , EN , CA/MCA or IEC.
- GB.3-V1 -