Using The Brakes - Ickle Bubba DISCOVERY Mode D'emploi

Using the Brakes

1. To engage the brake, press down on
either of the clips located over the back
wheels. Push past the second click to fully
engage the locking system and test to
ensure the brakes are fully engaged
WARNING: THE BRAKES MUST BE ENGAGED EACH TIME YOUR STOP
WITH YOUR CHILD IN THE STROLLER
Inserting and Removing the Bumper Bar
NOTE: The Discovery bumper bar has 4 sections to allow it to bend, and
for gate opening function
1. With the footbreak engaged,
attach the bumper bar to the
corresponding slots in the front of
the stroller
06
2.
To release the brake, lift either of
the clips upwards
2. Remove the bumper bar by
pressing the button lock under-
neath and pulling it outwards
V.01.21
Using the Front Wheels
2. To lock the front
1. To assemble, ensure
that the wheel lock
wheels into a fixed
mechanism is located
position, raise each
at the top of the wheel,
of the lock levers
then insert each wheel,
lock lever first, into the
found on the front
front of the pram until
of the wheels.
you hear a 'click'
WARNING: THE WHEELS MUST ALWA YS BE BOTH FIXED OR BOTH
SWIVEL FOR CORRECT USE OF THIS STROLLER
Using the Safety Harness
1. Connect each 2. To disconnect
side strap to the the harness, press
crotch strap the button in the
located in the centre of the crotch
centre of the seat strap
WARNING: ALWAYS USE STROLLER WITH THE CHILD STRAPPED WITH THE SAFETY
HARNESS! USE THE SAFETY HARNESS TOGETHER WITH THE CROTCH STRAP
3. To unlock the
wheels and allow
for better manoeu-
vrability, lower each
of the lock levers
3. To unfasten the
shoulder straps,
release the spring
clips connected to
the side straps
V.01.21
07