Using Texturz Texture Plates - SIZZIX BIGkick Mode D'emploi

Using Textured Impressions,
Texture Fades, Texture Trades
Embossing Folders or Embosslits Dies
Textured
Impressions
Embossing
Folder
Using a single
sheet of paper
A
With Textured Impressions, Texture Fades, Texture Trades
Embossing Folder or Embosslits Die open, insert paper, foil or
other embossable material, then close like a book.
Textured
Impressions
Embossing
Folder
Extended Multipurpose Platform
(Tab 1)
Place Cutting Pad above and below the closed Folder to
create a "sandwich."
Using Framelts, Thinlits
or Wafer-thin Dies
Framlits, Thinlits or
Wafer-thin Die
Extended Multipurpose Platform
(Tab 2)
Place material to be die-cut on Cutting Pad. Place Die over
paper or photo and align. Place another Cutting Pad over the
Die and paper to create a "sandwich."
Place sandwich on Extended Multipurpose Platform and slide
Platform into opening of BIGkick. Note the rotation of the
handle and continue to rotate it in the same direction until the
Platform has passed through the opening and the rollers.
Remove Platform from BIGkick. Your die-cut shape is ready to
use!
Using a
folded Card
B
Cutting
Pads
Single Sheet
of Cardstock
Cutting
Pads
Single Sheet
of Cardstock
"Sandwich"
Extended Multipurpose Platform
Textured
Impressions
Embossing
Folder
Extended Multipurpose Platform
(No Tabs)
Place Cutting Pad above and below the closed Folder to
B.
create a "sandwich."
Place sandwich on Extended Multipurpose Platform and slide
Platform into opening of BIGkick. Note the rotation of the
handle and continue to rotate it in the same direction until the
Platform has passed through the opening and the rollers.
Remove Platform from BIGkick. Your embossed material is
ready to use!

Using Texturz Texture Plates

Extended Multipurpose Platform
(Tab 1)
Place a Texture Plate directly on Tab 1 of the Extended
Multipurpose Platform with the desired design facing up. Place
paper or desired material on top of Texture Plate. Place Silicone
Rubber on top of paper. Place Impressions Pad on top of Silicone
Rubber to create a "sandwich."
Place sandwich on Extended Multipurpose Platform and slide
Platform into opening of BIGkick. Note the rotation of the
handle and continue to rotate it in the same direction until the
Platform has passed through the opening and the rollers.
Remove Platform from BIGkick. Your embossed material is
ready to use!
Cutting
Pads
Folded Card
"Sandwich"
Extended Multipurpose Platform
"Sandwich"
Extended Multipurpose Platform