Cleaning The Brush - POLTI SR25.9 Mode D'emploi

FORZASPIRA SR25.9 NA - M0S11418 - 1Q03:FEV 1000-950.qxd
Remove the filter unit.
click
Separate
protection mesh from the
filter.
Rinse all the components
under running water and let
them dry naturally away
from sources of heat for at
least 24 hours.
Replace everything repeating the steps de-
scribed previously in reverse order.
WARNING: Check that all the components
of the dust-collector tank are dry before
reassembling them.
WARNING: Check the filters during cleaning. Re-
place the filters when visibly damaged.
WARNING: Do not clean the filter with a
brush as it can be damaged, thereby redu-
cing the filtering capacity. Do not use deter-
gents, do not rub the filter, and do not wash
it in a dishwasher.
The filter should be replaced every 6 months.
The filters are sold at household appliance
stores, at Polti authorized service centres and
at www.polti.com.

5.2 CLEANING THE BRUSH

To clean the brush, proceed as follows:
Separate the brush from
the
pressing the release button
.
Turn the brush over and lift
the cylinder lock hook.
Remove the bristly
the filter Reposition everything and close the brush
again by performing the operations described
previously in reverse order.
6. STORAGE
- Ensure that the appliance is switched off
and not charging.
- Empty the dust-collector tank.
- Replace the appliance in the vertical posi-
tion.
vacuum unit by
cylinder.
| 11 |
22/03/2016 10.56 Pagina 11
Clean the bristly cylinder of
the brush.