General Maintenance; Cleaning The Filters - POLTI SR25.9 Mode D'emploi

FORZASPIRA SR25.9 NA - M0S11418 - 1Q03:FEV 1000-950.qxd
The brush has LED lights
which turn on when it is
started, ideal to help you
identify dirt on the surfaces.
3. PORTABLE VACUUM USE
Ensure that Chapter 1 has been followed.
Press the release button
click
to
handle.
Press the ON/OFF button to
turn it on.
click
To clean the most difficult
spots, move the suction
lance forward until you feel
it lock into place.
It is possible to attach the
small brush, located under
the portable vacuum, to the
suction lance.
To turn the appliance off,
press the ON/OFF button
click
again.
4. EMPTYING AND CLEANING THE
DUST CONTAINER TANK
When the dust-collector tank is full, turn the
appliance off.
of the portable vacuum
remove it from the
Close the door again on the dust-collector
tank.

5. GENERAL MAINTENANCE

Ensure that the appliance is switched off and
disconnected from the mains.
To clean the outside of the appliance, only use
a damp cloth and tap water.
Do not use detergents of any type.
Store the appliance in a cool, dry place, avoi-
ding extreme cold and heat, to protect bat-
tery performance.

5.1 CLEANING THE FILTERS

To clean the filters, proceed as follows:
- Empty the dust-collector tank as described
in Chapter 4.
| 10 |
22/03/2016
WARNING: Never exceed the "MAX" level
shown on the dust container, otherwise the
filters will clog reducing the suction power of
the appliance.
WARNING: To empty the dust collector, the
appliance must always be removed from the
handle.
Press the PUSH button to
open the tank and remove
the dirt collected.
click
WARNING: Pressing the PUSH button opens
the base of the tank, it is therefore recom-
mended that this operation be carried out
over a waste bin.
Clean after every use.
Press the
tank release
click
10.56 Pagina 10
dust-collector
button.