Replacing Remote Control Batteries; General Maintenance - POLTI FORZASPIRA MC 330 TURBO Manuel D'instructions

collector, pull out the filter unit and remove
any remaining dirt.
8.7 Replace the filter unit in the container.
8.8 Reinsert the filter under the cover of the
collector.
8.9 Reassemble the cover on the container
turning it clockwise, making sure to align the
two arrows (9).
8.10 Reposition the dust container on the ap-
pliance by repeating the steps described pre-
viously in the opposite order, making sure
that it is well attached.
We recommend to clean the container after
each use.
WARNING: Do not use the appliance without
the dust container complete with filter.
WARNING: Never exceed the "MAX" level
shown on the dust container, otherwise the
filters will clog reducing the suction power of
the appliance.
9. REPLACING REMOTE CONTROL
BATTERIES
In order to work, the remote control handle
must be power by two 1.5V AAA batteries.
The life of the batteries depends on how often
it is used.
If, when pressing any button on the remote
control, the control operation indicator light
does not come on
does not respond to the remote control com-
mands, replace the batteries.
Take the remote control handle, press the le-
ver of the battery cover pulling it towards the
remote control keypad (1).
Remove the cover and replace the batteries
making sure that the + and - marks match
what is indicated. Replace the cover.
WARNING: to protect the environment, we
recommend disposing of the battery in the
special recycling containers, in accordance
with the instructions of the manufacturer.

10. GENERAL MAINTENANCE

Ensure that the appliance is switched off and
disconnected from the mains.
To clean the outside of the appliance, only use
a damp cloth and tap water.
Do not use detergents of any type.
and the vacuum cleaner
10.1 CLEANING THE DUST CONTAINER
- Pull out the dirt container and remove the
container filter and the filter unit, as described
in the chapter 8.
- Rinse all the components under running wa-
ter and let them dry.
- Replace everything repeating the steps de-
scribed previously in the reverse order.
ATTENTION: Check all components of the du-
st collector are dry, before put them in order.
We recommend to clean the container after
each use.
10.2 REMOVAL AND CLEANING OF THE EPA
FILTER
For model MC 330_TURBO only
- Turn the grill anti-clockwise (10) and remove
the filter (11).
- Rinse the filter using running water only and
shake gently to remove any excess dirt or wa-
ter residue; before replacing the filter in the
appliance, leave to dry naturally away from di-
rect light and heat for at least 24 hours.
The filter should be fully cleaned approxima-
tely every four months.
WARNING: Check the filters during cleaning.
Replace the filters when visibly damaged.
WARNING: Do not clean the filters with the
brush as they can be damaged, reducing
their filtering capacity. Do not use deter-
gents, do not rub the filter, and do not wash
it in a dishwasher.
10.3 REMOVAL AND CLEANING OF THE HE-
PA FILTER
For model MC 350_TURBO & FRESH only
- Turn the grill anti-clockwise (10) and remove
the filter (11).
- Shake gently to remove any excess dirt or
water residue
The filter should be fully cleaned approxima-
tely every four months.
WARNING: Check the filters during cleaning.
Replace the filters when visibly damaged.
10.4 CLEANING CAP
- On the bottom of the appliance there is a
cap for cleaning the internal hoses, created to
remove any accumulation of dirt which can-
not pass into the suction container. To open it,
| 21 |