Battery Replacement On Remote; Charging The Generator Battery - Firman W03083 Manuel Du Propriétaire

ALWAYS disconnect the negative (-) battery
cable (black boot) first when disconnecting
battery cables.
NEVER connect the negative (-) battery cable
(black boot) to the positive (+) post on the
battery.
NEVER connect the positive (+) battery cable
(red boot) to the negative (-) post on the battery.
NEVER touch both battery posts simultaneously.
NEVER place a metal tool across both battery
posts.
ALWAYS use insulated or nonconducting tools
when installing the battery.

Battery Replacement On Remote

1. Loosening and remove cover screws.
2. Remove the cover.
3. Remove the depleted batteries and insert
two new CR2016 lithium batteries with the
"+" terminal facing up.
4. Close the remote cover and tight the screws.

Charging The Generator Battery

WARNING
WARNING
To ensure the battery remains charged, the
supplied battery charger should be plugged
into the generator. Plug the cord from the
charger into the charging port on the generator
control panel. Plug the charger into a 120 volt
AC wall outlet.
English
Lithium Battery
There is a light on the charger. This light will
remain red until the battery get charged and
then it will be changed to green. The charger
won't charge the battery or will stop charging
when the light is green to prevent any damage
to battery and generator.
Unplug battery charger from wall outlet and
generator control panel when generator is
going to be used.
Page 27 Customer Service: 1-844-FIRMAN1