Need Help - Fellowes Helios 30 Mode D'emploi

BEFORE BINDING
1.
Ensure the machine is on a stable surface. Check
there is enough clear space around the machine to
operate safely.
2.
Select the correct power lead for the appropriate
power supply. Insert the power lead into the power
socket (located at the rear of the machine).
HOW TO BIND
5.
Switch the power on (located at the rear side).
6.
The 'Power-On' button will be red. To activate the
machine, press the 'Power-On' button on the control
panel. The machine will warm-up, the red LED will
flash. The machine will 'beep' (3x) and the LED turns
green when the machine is ready to bind.
7.
Prepare the documents by loading the sheets into the
thermal covers. For best results, do not to place too
many or too few sheets into the cover. Use the bind-
ing thickness scale as a guide. The guide is calibrated
in 6mm widths. Helios 30 will accept single or
multiple documents up to a combined total thickness
of 30mm (approximately 300 sheets / 80gsm).
8.
The selected binding cycle is shown with blue LED.
Use the timer selection buttons to navigate up or
down the scale, if required. The scale has 10 settings.
Eg: 6mm document thickness = setting 1 (up to 60
sheets), 30mm document = setting 10 (up to 300
sheets).

NEED HELP?

6
3.
Plug the machine into an easily accessible mains
socket. Switch the mains supply on.
4.
Open and lift the lid by releasing the safety catches
on the front of the lid.
9.
Pull open the document clamp (Heat-Shield feature),
insert the documents into the binding channel.
Ensure the binding covers spine touches the heating
element.
10.
Start the binding cycle by pressing the 'Select / OK'
button. The blue LED will start flashing and counting
down, in sequence. When the cycle is complete, the
machine will beep (3x). The blue LED will switch off.
11.
The machine has an integral cooling tray. It can be
extended from the back of the machine and can also
be pulled upwards to accept larger documents.
12.
When the binding cycle is complete, immediately
remove the documents and place in the cooling tray
or on a flat surface to allow the document to cool.
The document can be removed from the machine
mid-cycle if required, take care – the glue may be
hot and melted.
Let our experts help you with a solution.
www.fellowes.com
Customer Service...
Always call Fellowes before contacting your place of purchase,
see the rear cover for contact details.