Servicing And Maintenance - Speck pumpen BADU Jet active Notice D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Scope of delivery (only for BADU Jet impulse)
Accessories (optional)
Using the massage hose
a)
*) Not applicable
for BADU Jet stan-
dard and BADU
b)
Jet active.

11. - Servicing and Maintenance

The unit should be periodically tested for operational safety, especially
the following areas:
Please also observe VDE 0100 Part 620
We reserve the right to make technical changes.
49
- Massage hose for large nozzle, 40 mm
- Pulsator for large nozzle, 40 mm
- Massage hose for large nozzle, 40 mm
- Massage hose for small nozzle, 28 mm
- Massage hose with pulsating massage nozzle for large nozzle, 40 mm
- Massage hose with pulsating massage nozzle for small nozzle, 28 mm
- Pulsator for large nozzle, 40 mm
- Pulsator for small nozzle, 28 mm
- Pinpoint massage nozzle for large nozzle, 40 mm
- Pinpoint massage nozzle for small nozzle, 28 mm
- Cap for large nozzle, 40 mm
- Cap for small nozzle, 28 mm
- Telescoping safety support for above-ground pools
The massage hose, i.e. water massage in general, should only be
used after consulting a physician. Do not allow children to use the mas-
sage hose!
The air regulator should be shut off before massage, because
otherwise water may be forced out through it due to the increased
pressure.
1. Watertight connection between hydraulic parts and motor
2. Stability of unit. All impurities should be removed.
3. All electrical contacts in general should be checked.
4. Independent earth connection
- The pump may only be repaired by the manufacturer or a repair shop
designated by the manufacturer.
- In case of pump leakage, the pump may not be operated and must be
disconnected from the power supply.
09.05.2007 TB-b BTA_einhaengeanlagen_v2_engl.indd

Publicité

Table des Matières
loading

Table des Matières