Unauthorized Alterations And Production Of Spare Parts - Speck pumpen BADU Jet active Notice D'installation

2.3 Hazards in the event of non-compliance with the safety instructions
Non-compliance with the safety instructions may produce a risk to the
personnel as well as to the environment and the machine and results in a loss
of any right to claim damages.
For example, non-compliance may involve the following hazards:
- Failure of important functions of the machines/plant
- Failure of specifi ed procedures of maintenance and repair
- Exposure of people to electrical, mechanical and chemical hazards
- Endangering the environment owing to hazardous substances being
released.
2.4 Compliance with regulations pertaining to safety at work
When operating the pump, the safety instructions contained in this manual, the
relevant national accident prevention regulations and any other service and
safety instructions issued by the plant operator are to be observed.
2.5 Safety instructions relevant for operation
- If hot or cold machine components involve hazards, they must be
guarded against accidental contact.
- Guards for moving parts (e. g. coupling) must not be removed from the
machine while in operation.
- Any leakage of hazardous (e. g. explosive, toxic, hot) fl uids (e. g. from
the shaft seal) must be drained away so as to prevent any risk to
persons or the environment. Statutory regulations are to be complied
with.
- Hazards resulting from electricity are to be prevented (see for example,
the VDE Specifi cations and the bye-laws of the local power supply
utilities).
2.6 Safety instructions relevant for maintenance, inspection and assembly
work
It shall be the plant operator's responsibility to ensure that all maintenance, in
section and assembly work is performed by authorized and qualifi ed personnel
who have adequately familiarized themselves with the subject matter by
studying this manual in detail.
Any work on the machine shall only be performed when it is at a standstill, it
being imperative that the procedure for shutting down the machine described
in this manual be followed.
Pumps and pump units which convey hazardous media must be
decontaminated. On completion of work all safety and protective facilities must
be re-installed and made operative again.
Prior to restarting the machine, the instructions listed under „Initial Start-up"
are to be observed.

2.7 Unauthorized alterations and production of spare parts

Any modifi cation may be made to the machine only after consultation with the
manufacturer. Using spare parts and accessories authorised by the
manufacturer is in the interest of safety. Use of other parts may exempt the
manufacturer from any liability.
43
09.05.2007 TB-b BTA_einhaengeanlagen_v2_engl.indd