Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Exchanging the light bulb
For technical reasons the 300 W light bulb must be exchanged together with the
light assembly.
To make sure that the light bulb is defective, i.e. that it was not just switched off
by the thermostat (see part 8 of the Operations Manual), the light should be swit-
ched on again after approx. 30 minutes.
When removing the light unit proceed as follows:
1.
Switch unit OFF at the housing.
2.
Disconnect pump and light from the power supply.
3.
Undo the cover
4.
Remove unit from the pool edge.
5.
Pull unit from the pool and lay it down.
6.
Detach light cable from the junction box and pull it out.
7.
Remove the two screws at the light mantle
8.
Pull light assembly together with connecting cable from the housing.
9.
Return light assembly to your dealer - or directly to the manufacturer - for
replacement.
10. Reassemble the light assembly in reversed order.
51
09.05.2007 TB-b BTA_einhaengeanlagen_v2_engl.indd
Publicité
Table des Matières
