Filling Fuel - Toyotomi zibro RC-320 Manuel D'utilisation

B

FILLING FUEL

Fill the removable tank in a suitable place since there can always be some spillage .
Follow the procedure below:
1 Make sure that the heater is switched off .
2 Open the upper lid  and lift the removable tank  out of the heater (Fig . G) .
Put down the removable tank (cap pointing upwards, handle on the floor)
and screw off the fuel cap using the fuel cap cover (Fig . H) .
NOTE: Some drops may leak from the tank .
3 Take the manual fuel pump and insert the smooth, most rigid tube into the
jerrycan . Make sure that it is in a higher position than the removable tank
(Fig . I) . Insert the ribbed hose into the opening of the removable tank .
4 Lock the valve on top of the pump (turn clockwise) .
5 Squeeze the pump a few times, until fuel starts flowing into the removable
tank . As soon as this happens, there is no need to press any longer .
6 Check the fuel gauge of removable tank  while filling the tank (Fig . J) . Stop
filling by loosening the valve on top of the pump (turn anti-clock-wise), once
the gauge indicates that the tank is full . Never overfill the tank, especially not
when the fuel is very cold (fuel expands when it heats up) .
7 Let the remaining fuel in the pump flow back into the jerrycan and carefully
remove the pump . Carefully screw the fuel cap back on the tank (Fig . K) using
the fuel cap cover . After use, re-store the cover at the rear of the heater .
Clean off any spilled fuel .
8 Check whether the fuel cap is straight and tightened properly . Reinstall the
removable tank in the heater (cap down) . Close the lid .
NOTE: Be sure to tighten the fuel tank cap and confirm that there is no
leakage of the fuel when the cap side is placed down . Then insert the
removable fuel tank into the heater .
C
IGNITING THE HEATER
A new heater may give off some smells for a short while, when it is used for the
first time . You should therefore provide extra ventilation or ignite the heater
outside the living room .
When you use the heater for the first time, first put the filled removable tank into
!
place, and then wait approximately 30 minutes before you ignite the heater . This
allows the glass fibre wick to soak up the fuel . Follow the same procedure when
you have completely burnt up all fuel from the tank, and after the glass fibre wick
has been replaced .
Before igniting the heater, always check the fuel indicator  to see whether the
removable tank needs filling up (Green=full, Red=empty) .
Always ignite the heater with the knurled wick adjustment knob  . Never use
matches or a cigarette lighter .
Follow the procedure below:
1 Turn the knurled wick adjustment knob  clockwise to its stop (Fig . L) . If you
apply more pressure you may turn it slightly further; however, it will
automatically return to the start position . When you have set the wick to its
highest position, this action will automatically activate the safety device .
4
6
G
H
I
J
empty full
K
L