Toyotomi zibro RC-320 Manuel D'utilisation page 18

Masquer les pouces Voir aussi pour zibro RC-320:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42
F
ADJUSTING THE WICK HEIGHT
After a period of time the combustion may no longer be high enough (Section D) .
In that case you can adjust the wick height to improve the flame . To do this, the
heater must have been switched off . Follow the procedure below:
1 Push the OFF button  (Fig . N) .
2 Pull the knurled wick adjustment knob  off the heater, so the wick height
lock  will be visible .
3 Take the plastic collar between your thumb and index finger and pull it out .
Turn the collar up one step, to either position 2 or 3 (Fig . O) . Carefully push
the collar back, so the pin engages in the recess .
4 Carefully reinstall the knurled wick adjustment knob  . This can be done in
one way only - check the rear of the cap for the correct position .
!
If adjustment of the wick height does not have the required effect, let the heater
burn until all fuel has been used up (Section H) .
If the flame height is still too low and the wick is set on position 3, then contact
your dealer, or replace the wick, refer to Section M .
If the flame gets too high after adjusting (Fig R), the wick height lock should be
placed one position lower again . Otherwise smoke or soot may be caused .
G
MALFUNCTION, CAUSES AND SOLUTIONS
If any malfunctioning cannot be solved from the directions below, please contact
your dealer .
THE HEATER DOES NOT IGNITE
 The batteries are not positioned correctly in the holder .
Check (Fig. F) .
 There is not enough power left in the batteries for the ignition .
Replace (Fig. F) .
 You have run out of fuel from the tank or the wick has been replaced .
After having refilled and replaced the removable tank, wait for 30 minutes
before igniting the heater.
IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS
 The combustion chamber  has not been positioned correctly .
Use the handle  to put it level, until you can easily slide it slightly to the left
and to the right and the chamber is level.
 You are using fuel which is past its 'use by' date .
Start every heating season with fresh fuel.
 You are using the incorrect type of fuel .
Refer to THE RIGHT FUEL (See Section 'What you need to know in advance').
 Dust has gathered in the lower part of the heater .
Contact your dealer.
 Wick position wrong .
See Section F.
THE HEATER SLOWLY EXTINGUISHES
 The removable tank is empty .
See Section B.
 The fuel filter is contaminated by water .
Dry the fuel filter (Section H, Fig. P).
 The lower reservoir is contaminated by water .
Contact your dealer.
 The wick has hardened on the upper side .
Burn the heater until all fuel is used (Section H). Use the right fuel.
 You are using fuel which is past its 'use by' date .
Start every heating season with fresh fuel.
4
8
N
O
F

Publicité

Table des Matières
loading

Table des Matières