Toyotomi zibro RC-320 Manuel D'utilisation page 19

THE HEATER REMAINS BURNING LOW
 Wick position too low .
Reinstall the wick height lock (Section F).
 Before you refilled the tank, the heater had burnt up almost all the fuel .
After having refilled and replaced the removable tank, wait for 30 minutes
before igniting the heater.
 You are using the incorrect type of fuel .
Refer to THE RIGHT FUEL (See Section 'What you need to know in advance') .
 The room is insufficiently ventilated .
Leave a window or a door wide open for a while.
THE HEATER IS BURNING TOO HIGH
 The flame at the initial stage is tending to make higher flame due to the
brand new components . The flame will be lower after approximately 10 hours
combustion .
 You are using an incorrect, too volatile type of fuel .
Refer to THE RIGHT FUEL (See Section 'What you need to know in advance').
 Wick position too high .
Reinstall the wick height lock (Section F).
H
MAINTENANCE
Your heater needs hardly any maintenance . It is, however, important that you
remove dust and stains in time with a damp cloth, because otherwise these may
cause stains that are hard to remove . Under normal conditions, only 4 components
are subject to wear:
1. THE BATTERIES
You may replace the batteries yourself . Check the spark discharge sound . If the
sound is cracked, the voltage of the battery is low . Please change the battery .
Check the ignition plug following the maintenance procedure 3 if the sound
does not change even after the replacement of the battery . Do not dispose of
old batteries along with the other domestic waste . Follow the locally applicable
regulations regarding the disposal of domestic chemical waste .
2. THE WICK
To extend the glass fibre wick life, you must occasionally let the heater burn until
the tank is completely emptied and the heater extinguishes by itself . Do this when
you notice that the flame is weakening . The burn-out will cause some smells, so it
is recommended that you take the heater outside of the living room .
3. ELECTRODES
When the electrodes gets dirty by carbon or tar, clean the electrodes . If the
electrodes digs into the wick, it may cause the ignition failure . Then fix the
position of the electrodes . Be sure not to spill the water on the electrodes .
4. THE FUEL FILTER
Check the fuel filter regularly as well .
Remove the removable tank  from the heater and take out the fuel filter (Fig .
P) . Some drops of fuel may spill from the filter; keep a cloth at hand . Turn the
fuel filter upside down and clean it from all dirt deposits by tapping it on a hard
surface . (never clean it with water!) Reposition the fuel filter in the heater .
!
Do not remove any heater components yourself . Always contact your dealer for
repairs .
!
Let the heater cool down first, before you start any maintenance or service work .
!
For maintenance, wear gloves for your safety .
fuel filter
P
4
9