Toyotomi zibro RC-320 Manuel D'utilisation page 17

When you have ignited the heater and it shuts off again shortly after, the batteries
need to be replaced . It is best to use new alkaline batteries (4x D-size) .
!
If the heater has been used only a few times and the wick adjustment knob is
not locked, first turn the wick adjustment knob (Fig . M) completely left, before
putting the wick in the highest position for ignition (Section C) .
After having ignited the heater, always check whether the combustion
!
chamber  is level, by sliding it slightly to the left and the right by its handle
 (Fig . E) . This should be a smooth movement . If the combustion chamber is not
level, this will cause smoke and soot to develop .
D
BURNING OF THE HEATER
After you have ignited the heater, it will take 30 minutes before you can check
whether the heater is burning well . Too high a flame may cause smoke and soot,
whereas too low a flame causes smells .
✗
!
If the flame remains low after the adjustment, the wick height must be
adjusted (refer to Section F) .
Burning that is too low may be caused by:
 insufficient fuel
 poor fuel quality
 insufficient ventilation
 wastage of the wick (contact your dealer or replace the wick, refer to Section M)
When there is insufficient ventilation in the room, the heater shuts off
automatically . After improving the ventilation of the room (e .g . by opening a
door or window a little more), the heater can be ignited again .
This heater is equipped with a safety mechanism which switches off the heater
!
when the removable fuel tank is taken out of its compartment (Fig . G) . To
re-ignite the heater, place the removable fuel tank back in the heater and follow
the instructions as described in Section C .
E
SWITCHING OFF THE HEATER
Push the OFF-button  . The flame will extinguish after a little while (Fig . N) .
✓
(fill the tank)
(contact your dealer)
(put window or door ajar)
✗
 R
4
7
M
E
G