Kthe 'Fuel' Indicator - Toyotomi Toyoset LC-3010 Manuel D'utilisation

J
THE CORRECT USE OF 'SAVE'
The 'SAVE' function allows you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature
exceeds the set temperature by 3°C. Subsequently, when the room temperature has
dropped again to the set temperature, the heater will automatically switch on again.
Activate the 'SAVE' setting by pressing the appropriate
light will light up (Fig. J). Switch off the function by pressing the SAVE key once
again.
Without the 'SAVE' setting your heater will maintain the set temperature by
!
approximation as well, by adjusting its heating capacity. 'SAVE' is an economy
setting, which you can use when, for instance, you are not present in the room or
to keep it frost-free.
K
THE 'FUEL' INDICATOR
When the FUEL indicator appears, it means that there is only fuel left for 10
more minutes. The count-down of the remaining heating time can be seen in the
information display ¸ (Fig. K).
You remove the fuel tank and refill it outside the living room (Section B).
In the display the number 10 will appear, you will hear an alarm signal every
two minutes, warning you to refill the removable tank. If you do not react, the
heater will extinguish by itself. The heater will also sound a warning signal,
when it switches off. The fuel indicator will blink, while four lines (--:--) are
blinking in the information display. You can stop this by pressing the
¹ once more.
Once the heater has used up all its fuel and extinguished, it will take some time,
after the refill, before the heater is completely ready for use again.
L
THE 'VENT' INDICATOR
When the VENT indicator starts blinking, this is a sign that the room is not vented
sufficiently (Fig. L). The heater will switch off automatically. If the indicator
continues blinking after extra ventilation, please contact your dealer.
M
MAINTENANCE
Switch off the heater and let it cool down, before you start any maintenance
work. Also disconnect the plug from the mains. Your heater needs hardly any
maintenance. It is, however, important that you clean the vent filter
vacuum cleaner and the grid
Regularly inspect the fuel filter as well:
1 Remove the removable tank
(Fig. M). Some drops may leak from the filter; keep a cloth at hand.
2 Remove the dirt by tapping the fuel filter upside-down against a hard surface.
(Never clean it with water!)
3 Reinstall the fuel filter into the heater.
We recommend that you remove dust and stains from time to time with a damp
cloth, because otherwise these may cause stains that are hard to remove.
with a damp cloth, both on a weekly basis.
from the heater and remove the fuel filter
key. The SAVE indicator
button
with a
J: When the SAVE light
lights up, the heater will
automatically switch on
or off in order to remain
within a specified tem-
perature range.
K: When the FUEL
indicator has appeard,
the information display
will show the number of
minutes of fuel left in
the tank.
L: A blinking VENT
indicator is a sign
that you need extra
ventilation.
Fuel filter
M
4
9