Installing The Heater - Toyotomi zibro RC-320 Manuel D'utilisation

manUal
A

INSTALLING THE HEATER

1 Carefully remove your heater from the box and check the contents .
In addition to the heater you also need to have:
 a manual fuel pump
 a transportation cap
 a fuel cap cover
 these directions for use
Keep the box and the packaging materials (Fig . A) for storage and/or
transportation .
2 Remove the other packaging materials:
 Remove the packaging material from the grill  . Lift the grill from the slot
(Fig . B) and pull it forward .
 Push the packing material on top of the combustion chamber  slightly
down and remove it (Fig . C) .
 Remove the packaging materials from under the combustion chamber as
well (Fig . D) .
 Put the combustion chamber back into its place . The combustion chamber
is positioned correctly when it can be smoothly moved a little to the left
and to the right by its handle  (Fig . E) . Close the grill: Slightly lift it to
reposition it in its slot .
 Open the lid of the removable tank  and remove the piece of cardboard .
3 Fill the removable tank as indicated in Section B .
4 By removing the screw to remove the cover and insert the batteries into their
holder  at the back of the heater (Fig . F) .
Ensure that the positive and negative poles match the + and - marks indicated
on the battery housing . It is best to use new alkaline batteries (4x D-size) .
5 The floor should be firm and completely level . Reposition the heater, when it
is not level . Do not correct the situation by placing books or other goods
under the heater .
6 Your heater is now ready for use .
!
Do not use the heater at a height of over 1500 meters .
A
B
C
D
E
F
4
5