DURASWEEP 50&70
OPERATING MANUAL
SPECIFIC OPERATIONS FOR BATTERY POWERED MODELS 50&70BT
________________________________________________________________________________________________
FOR OPERATIONS RELATIVE TO THE BATTERY, FOLLOW THE INSTRUCTIONS DESCRIBED IN
CHAPTER SAFETY RULES AND REGULATIONS IN THE PARAGRAPH RESIDUAL RISKS FOR
BATTERY POWERED MODELS.
So that the batteries last as long as possible, recharge them as soon as the volt meter goes into the red zone. If the
accumulators go excessively low, the performance is reduced and their life is consequently shorter.
At each charging cycle, check the level of the sulphuric acid solution in the elements of the battery. Top up with distilled
water if necessary.
Always complete the recharge cycle without interrupting it.
Ask the Dealer or Supplier to send qualified personnel to check the electric motor brushes every 200 working hours.
BATTERIES, NEW BATTERIES INCLUDED, THAT ARE ALLOWED TO RUN COMPLETELY FLAT CANNOT BE RE-
12
EXTRAORDINARY MAINTENANCE
EXTRAORDINARY MAINTENANCE MEANS ANY OPERATION NOT INCLUDED IN THE CHAPTER
ROUTINE MAINTENANCE. ALL SPECIAL MAINTENANCE OPERATIONS HAVE TO BE MADE BY
MANUFACTURER'S OR DEALER'S QUALIFIED STAFF ONLY.
13
LEAVING THE MACHINE UNUSED FOR LONG PERIODS
Leave the machine running to use all the petrol in the tank. Once the machine stops for lack of fuel, wait for the motor to
cool down and then clean the filters and refill the container thoroughly.
Remove the batteries from their housing and store them in a cool ventilated place. The batteries, even if not used, must
be recharged every 30 - 40 days. After the same period check the level of sulphuric acid solution and top up if necessary.
Thoroughly clean the filters and refuse container.
14
DISMANTLING / DEMOLITION
THE DESTRUCTION OR DEMOLITION OF THE MACHINE MUST BE CARRIED OUT BY THE OWNER
WITH TOTAL OBSERVATION OF THE LAWS IN FORCE. IT IS ADVISABLE TO UTILISE COMPANIES
SPECIALISED IN THIS SECTOR.
V01
CHARGED.
MODEL IN ENDOTHERMIC VERSION
MODEL IN ELECTRIC VERSION
TSM - Technological Systems by Moro Srl
Via F.lli Zambon,9 - 33080 Fiume Veneto (PN) – Italy
Tel. +39.0434.564167 - Fax +39.0434.954069
www.tsmitaly.com – sales@tsmitaly.com
33