Control Panel - OHAUS ISHD16HDG Manuel D'instructions

Incubating Shaker

1.6. Control Panel

F
E
J
D
The front panel of the Incubating Orbital Shaker contains all the controls and displays needed to operate the
unit
A. Standby button/standby indicator light: The standby indicator light will illuminate when the unit is
plugged in. The unit will be in standby mode. Press the standby button to activate the temperature,
speed and time functions. The standby indicator light will shut off and the temperature, speed and time
displays will illuminate. Press the standby button again and the unit will once again be in standby mode.
B. Temperature display: Displays the actual/set-point temperatures in conjunction with the actual/set-
point indicator lights.
C. Up/down arrows for set-point control. On/off button starts/stops the heating function.
D. The heat indicator light will be illuminated when the unit is heating.
E. Actual indicator light: Illuminates when the temperature displayed is the actual temperature of the air
in the chamber.
F. Set-point indicator light: Illuminates when the set-point temperature is displayed.
G. Caution hot indicator light: Illuminates when the air temperature of the chamber is above 40°C
(104°F).
H. Speed display: Displays the speed of the shaker.
I. Up/down arrows for set-point control. On/off button starts/stops shaking function.
J. The speed indicator light will be illuminated when the unit is shaking.
K. Time display: Displays accumulated time (continuous mode) or how much time is remaining (timed
mode). The display range is from 0 to 9,999 minutes in one (1) second increments. The display will
indicate minutes and seconds until the timer reaches 99 minutes and 59 seconds (99:59), then the
display will automatically display minutes up to 9,999.
L. Up/down arrows for set-point control. On/off button starts/stops the time function.
B H
G
I
C
K
L
A
EN-7